Live Chat
Available 24/7
The PRO-WELL-1E is intended to treat up to 2 ppm hydrogen sulfide, which can be associated with rotten-egg odor. ProA...
The main settings that may need adjustment are Setting 1 for time of day and Setting 3 for capacity in gallons. Final...
Replacement timing depends on water conditions and usage, but the typical range is every 6 to 12 months. For well wat...
ProAqua does not provide installation cost estimates because pricing varies by home, region, and install complexity. ...
Residential systems can be installed outdoors only if they are fully protected from direct sunlight, rain, and genera...
Ask the customer to email hi@proaquawater.com with photos of the control valves and media tanks so support can confir...
Support should route the customer to hi@proaquawater.com for apartment-specific fit and plumbing review.
18 GPM
A customer can use a separate 3-valve bypass, but ProAqua recommends the included manufacturer bypass because it is t...
PRO-RO-I uses 120V. PRO-RO-II and PRO-RO-IV use 220V.
Proper pretreatment is critical. A standard setup is staged sediment pre-filtration such as 20 micron followed by 5 m...
2.5 cubic feet
The system includes the components shown in the product listing photos and described in the "What's Included" section...
Close the bypass gradually to blend treated and untreated water until the desired feel is reached.
The gauges show the incoming line pressure across all three stages.
Filtration can remove contaminants, but it does not soften water. Hard water requires a softener or conditioner to re...
Yes. A water test helps identify the contaminants present and is the safest way to recommend the correct filtration s...
Depending on the system and water conditions, a well water setup can address iron, sediment, sulfur, manganese, bacte...
Available 24/7
800-980-3335
Mon - Fri | 8:00am - 4:00pm PST
hi@proaquawater.com
We'll get back to you ASAP