Admin
- Total activity 45
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 0
Articles
Recent activity by Admin-
Can the PRO-WELL-1E backwash interval be set longer than 3 days?
Yes, the interval can be changed from 24 to 940 hours, but 72 hours has been the most effective setting for preventing media fouling.
-
How do I clean or sanitize the WS-P-16?
Direct the customer to hi@proaquawater.com for model-specific cleaning guidance.
-
How often should I replace the WS-P-16 pre-filter?
Every 3 months.
-
How much salt does the WS-P-16 use during regeneration?
With the WS-P-REG-KIT, use 26 oz of non-iodized table salt. Without the kit, use 4 lbs of non-iodized salt.
-
What is the PSI drop from the control head?
A small pressure drop is normal through the control valve. The actual drop depends on plumbing configuration and flow rate.
-
Is it normal to have water in the brine tank?
Yes. The water level changes based on the amount of salt in the tank, but it should generally be 2 to 5 inches above the top of the salt. Do not exceed 80 lbs of salt in the brine tank.
-
Can I install the FC-10-ALK in the PRO-100-E?
No. The FC-10-ALK is a 10" filter and is too small for the PRO-100-E.
-
What maintenance does the PRO-WELL-1E require?
The unit is generally self-sustaining and does not usually need regular external maintenance beyond proper programming, installation checks, and normal troubleshooting if issues appear.
-
How often should the PRO-WELL-1E backwash?
The default schedule is every 72 hours, usually at 2:00 AM. Frequency can be adjusted based on water quality and usage.
-
What does it mean when the PRO-WELL-1E screen shows hours instead of gallons?
It means the gallon capacity has been exhausted and the system is counting down to its scheduled regeneration time.