Admin
- Total activity 45
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 0
Articles
Recent activity by Admin-
Can the PRO-WELL-1E and PRO-S-80E backwash or regenerate at the same time?
ProAqua recommends setting them to different times so both units get proper water volume during their cycles.
-
How often should I replace a well-water filter?
Most filters should be replaced every 6 to 12 months, with some pre-filters needing more frequent service depending on water quality.
-
Does the PRO-WELL system remove rotten egg smell or hydrogen sulfide?
The PRO-WELL-1E is intended to treat up to 2 ppm hydrogen sulfide, which can be associated with rotten-egg odor. ProAqua recommends a water test before purchase so the customer can confirm the sour...
-
What programming settings need adjustment on the PRO-S-80E?
The main settings that may need adjustment are Setting 1 for time of day and Setting 3 for capacity in gallons. Final values depend on water hardness and household usage.
-
How do I know when the PRO-100-E filters need replacement?
Replacement timing depends on water conditions and usage, but the typical range is every 6 to 12 months. For well water, replace every 4 to 6 months; for city water, every 6 to 12 months.
-
Do you know how much a plumber charges for installation?
ProAqua does not provide installation cost estimates because pricing varies by home, region, and install complexity. Customers should get quotes from a few licensed local plumbers.
-
Can these systems be installed outdoors?
Residential systems can be installed outdoors only if they are fully protected from direct sunlight, rain, and general weather exposure. A weatherproof enclosure is strongly recommended. Commercial...
-
BNDL-WEL setup issue: control valves on the wrong media tanks
Ask the customer to email hi@proaquawater.com with photos of the control valves and media tanks so support can confirm the installation layout and give model-specific guidance.
-
Can the WS-P-16 be installed in an apartment?
Support should route the customer to hi@proaquawater.com for apartment-specific fit and plumbing review.
-
What is the flow rate for the PRO-S-80E?
18 GPM