Admin
- Total activity 45
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 0
Articles
Recent activity by Admin-
Is it normal to have water in the brine tank?
Yes. The water level changes based on the amount of salt in the tank, but it should generally be 2 to 5 inches above the top of the salt. Do not exceed 80 lbs of salt in the brine tank.
-
Can I install the FC-10-ALK in the PRO-100-E?
No. The FC-10-ALK is a 10" filter and is too small for the PRO-100-E.
-
What maintenance does the PRO-WELL-1E require?
The unit is generally self-sustaining and does not usually need regular external maintenance beyond proper programming, installation checks, and normal troubleshooting if issues appear.
-
How often should the PRO-WELL-1E backwash?
The default schedule is every 72 hours, usually at 2:00 AM. Frequency can be adjusted based on water quality and usage.
-
What does it mean when the PRO-WELL-1E screen shows hours instead of gallons?
It means the gallon capacity has been exhausted and the system is counting down to its scheduled regeneration time.
-
Can the PRO-WELL-1E and PRO-S-80E backwash or regenerate at the same time?
ProAqua recommends setting them to different times so both units get proper water volume during their cycles.
-
How often should I replace a well-water filter?
Most filters should be replaced every 6 to 12 months, with some pre-filters needing more frequent service depending on water quality.
-
Does the PRO-WELL system remove rotten egg smell or hydrogen sulfide?
The PRO-WELL-1E is intended to treat up to 2 ppm hydrogen sulfide, which can be associated with rotten-egg odor. ProAqua recommends a water test before purchase so the customer can confirm the sour...
-
What programming settings need adjustment on the PRO-S-80E?
The main settings that may need adjustment are Setting 1 for time of day and Setting 3 for capacity in gallons. Final values depend on water hardness and household usage.
-
How do I know when the PRO-100-E filters need replacement?
Replacement timing depends on water conditions and usage, but the typical range is every 6 to 12 months. For well water, replace every 4 to 6 months; for city water, every 6 to 12 months.